1) The BEQ instructions is used _
To check the equality condition between the operands and then branch![]()
To check if the Operand is greater than the condition value and then branch![]()
To check if the flag Z is set to 1 and then causes branch![]()
None of the mentioned![]()
Answer : C Discuss
2) The condition to check whether the branch should happen or not is given by _____
The lower order 8 bits of the instruction![]()
The higher order 4 bits of the instruction![]()
The lower order 4 bits of the instruction![]()
The higher order 8 bits of the instruction![]()
Answer : B Discuss
3) ___ directive is used indicate the beginning of the program instruction or data.
4) ____ directive specifies the start of the execution.
5) ____ directives are used to initialize operands.
6) _____ directive is used to name the register used for execution of an instruction.
7) THe pseudo instruction used to load address into the register is _____
8) The addressing method used in IA-32 is _
9) The The Floating point registers of IA-32 can operate on operands up to __
10) The size of the floating registers can be extended upto __