To test for AC ripple on a PC power supply, you would set the volt/ohm meter for
Home | Discussion ForumTo test for AC ripple on a PC power supply, you would set the volt/ohm meter for:
DC voltage scale
AC voltage
OHM scale
Farad scale
Answer : B
Free Online Test
View More Related Question
1) To install a second IDE drive into a computer, you must:
Set the master-slave jumper to slave on the second drive
Use the IDE configuration software to set the new drive as slave
Verify that you define the new drive as D: in the CMOS setup
Verify that you attach the drive to the connector at the end of the ribbon cable
View Answer
2) Which device is on IRQ 6?
3) The floppy drive uses which DMA (direct memory access) channel?
4) A COM port is a _____ port.
5) ESD potential decreases with the use of: